Bracelet & Necklace Pro

Start by using your beadboard to measure the desired length of thread (bracelet is 13–20 cm / necklace is 41–56 cm).

Lay out your beads, charm, and logo in a design you vibe with, then feed the wire through them.

Thread one end of the jewelry wire through a connector and then through a clasp. Then thread the wire back through the same connector before pulling it tight.

Next, follow the three steps to enclose the beads. Repeat on the other end of the wire with an o-ring instead of a clasp.

Finally, gently pull the wire and clasp to test the closure’s strength, then trim the excess wire — but leave a little length so you can weave it into the nearest beads.